The deltaflow pitot tube – flowmeter for gas, liquids and steam. Reliable, cost-effective, accurate.

The ultrasonic transit-time flowmeter deltawave – flowmeter for open channels, filled pipes and rivers

The air flow regulation unit deltafit – saves air, saves costs, optimizes your process.

Clamp-on ultrasonic flowmeters from fuji – contactless flow measurement: simple, cost-effective, accurate

Flowmeters for the chemical industry

The >> deltaflow pitot tube is the solution for measuring the gas-flow in pipes. No matter if products, exhaust air, flue gases. Pure or polluted media, inert or aggressive, the deltaflow can almost always offer a solution. Diameters are available from 15mm to 15.000mm. The deltaflow has proved its high resistance at Wacker Chemie in Burghausen. During a hardness test of several months in a waste incineration plant, the German TÜV tested the deltaflow in aggressive and dirty flue gas 100% saturated with steam. Reward for the efforts: UAL certification under Germany’s “TA-Luft” air-quality regulations and 13th and 17th Federal Emission-Control Ordinances.

deltaflow for natural gas

The same principle can be used for steam and hot water applications. Even for high pressure the deltaflow can still be used, for pressures until 640 bar and temperatures until 1240°C. The deltaflow can resist! If high pressure steam applications, boiler feed water or boring heads for natural gas are concerned, in any case the deltaflow has proved its reliability and efficiency for years. Of course you can use the deltaflow also for hazardous locations.

flowcomputer for heating transfer

Cooling or heating transfer media are other current applications of the deltaflow, in combination with the >> flowcom. The deltaflow can be used to measure the flow of the ammonia return while the flowcom can calculate the delivered quantity of cooling from the differences of the out- and ingoing pressures and temperatures.

Flow measurement in subsurface channels

Open sewers, partially filled pipes, discharge of waste water to surface waters or drawing-off of water for industrial uses – the >> ultrasonic flowmeter deltawave is specialised for this measurements in filled/partially filled channels and pipes. Adapted to the existing measuring point, the installation costs for the highly sensitive ultrasonic transit time measurement are very low.

ultrasonic flowmeter for filled pipes

There are several advantages of the >> fuji-ultrasonic measurement for liquids, compared to other methods: no need to cut the pipe, no pressure loss, no conductivity required, wide measuring range, very low installation costs … fur just mentioning some of the most striking. The portable portaflowX can check or replace existing instruments for the flow measurement in a couple of minutes. TimeDelta, the stationary model, executes the same task for permanent installations.

Don’t worry. We will be happy to provide you with a individual solution for your specific measurement application. Please contact your >> contact person or local distributor You can also use the form to ask for further information or to describe your application. We will be happy to support you!