High energy costs for your air supply? Save money with a precise air flow regulation for your aeration tanks? With deltafit you’ll get ready-for-use unit for your supply pipes.

The tried-and-tested ultrasonic flowmeter deltawave is now ready for flow measurement applications in rivers and big channels.

more than 230bar burst pressure makes the new deltawave HD-transducer for flow measurement perfect for hydro power applications and lekage detection systems.

Important Notice : Software in our download area has been ofently compressed to zipped format using WinZip. Copy files to a temporary folder on your local drive, unzip them, and then start the setup program. Software in this location has been scanned with current virus-scanning software. However, we recommend on general principle that you scan all files downloaded from the Internet with your own current virus-scanning software before installing them.

deltacalc 4.x is a powerful freeware tool useful for calculating the dp of dp-primary devices.
Of course, deltacalc 3.x calculates data from the deltaflow flow probe, as well as from flow probes produced by other manufacturers and ISO-primary devices such as Orifices, Nozzels and Venturis (ISO 5167 / DIN 1952 / VIS VED 2040) with known dimensions.
deltacalc 4.x is a DEMO Software with lots of free function. Registered Users will have additional features. We welcome your comments and feedback.

flowcom 1.35 is communication software designed to facilitate the easy setup of flowcom software (ver 1.x) on the PC via a serial port connection. flowcom 1.35 communication software can be used to set up either flowcom energy or flowcom gas systems.

flowcom parameters can be modified via the serial port RS232; settings and measurements can be stored on a PC hard drive, printed out, and displayed on the flowcom itself using flowcom 1.35 communication software.
In addition, flowcom 1.35 communication software makes it possible to output data from datalogs and display error protocol data, integrator data, and previous values measured by flowcom on a PC system. Using flowcom 1.35 communication software, users can easily modify all physical flowcom units, whether displayed or stored.

The demo version of flowcom 1.35 is intended for demonstration purposes only; storage and serial port operation features have been disabled in the demo version. Please enter “DEMO” when prompted for the serial number during the setup process. A complete version can be obtained from systec Controls or our representative partners.

flowcom 2.10 communication software works seamlessly in conjunction with flowcom units versions 2.0 and higher.
Naturally, flowcom 2.10 communication software supports the expanded display options of the new flowcom generation, such as the ability to completely customize the display, comment fields, and balancing features, etc.
Please enter “DEMO” when prompted for the serial number during setup of the demonstration version. Some features of the software are disabled in the demo version.
The fully licensed version of the software is available from systec controls and from our representative partners.

the software “flowcom ascii protokoll tester” is a small tool, to check the connection between your flowcom and you pc. Just download the software, connect flowcom and PC and choose the COM-Port. the software shows you if your hardware and software is setup correctly. Warning: one may zero flowcom totalizers when using this software.